\(\renewcommand{\AA}{\text{Å}}\)

fix accelerate/cos command

Syntax

fix ID group-ID accelerate value

  • ID, group-ID are documented in fix command

  • accelerate/cos = style name of this fix command

  • value = amplitude of acceleration (in unit of velocity/time)

Examples

fix 1 all accelerate/cos 0.02e-5

Description

Give each atom a acceleration in x-direction based on its z coordinate. The acceleration is a periodic function along the z-direction:

\[a_{x}(z) = A \cos \left(\frac{2 \pi z}{l_{z}}\right)\]

where \(A\) is the acceleration amplitude, \(l_z\) is the \(z\)-length of the simulation box. At steady state, the acceleration generates a velocity profile:

\[v_{x}(z) = V \cos \left(\frac{2 \pi z}{l_{z}}\right)\]

The generated velocity amplitude \(V\) is related to the shear viscosity \(\eta\) by:

\[V = \frac{A \rho}{\eta}\left(\frac{l_{z}}{2 \pi}\right)^{2}\]

and it can be obtained from ensemble average of the velocity profile:

\[V = \frac{\sum\limits_i 2 m_{i} v_{i, x} \cos \left(\frac{2 \pi z_i}{l_{z}}\right)}{\sum\limits_i m_{i}},\]

where \(m_i\), \(v_{i,x}\), and \(z_i\) are the mass, \(x\)-component velocity, and \(z\)-coordinate of a particle, respectively.

The velocity amplitude \(V\) can be calculated with compute viscosity/cos, which enables viscosity calculation with periodic perturbation method, as described by Hess. Because the applied acceleration drives the system away from equilibration, the calculated shear viscosity is lower than the intrinsic viscosity due to the shear-thinning effect. Extrapolation to zero acceleration should generally be performed to predict the zero-shear viscosity. As the shear stress decreases, the signal-noise ratio decreases rapidly, the simulation time must be extended accordingly to get converged result.

In order to get meaningful result, the group ID of this fix should be all.

Restart, fix_modify, output, run start/stop, minimize info

No information about this fix is written to binary restart files. None of the fix_modify options are relevant to this fix. No global or per-atom quantities are stored by this fix for access by various output commands. No parameter of this fix can be used with the start/stop keywords of the run command. This fix is not invoked during energy minimization.

Restrictions

This command is only available when LAMMPS was built with the MISC package. Since this fix depends on the \(z\)-coordinate of atoms, it cannot be used in 2d simulations.

Default

none

(Hess) Hess, B. Journal of Chemical Physics 2002, 116 (1), 209–217.